PA6.6 – Polyamide 6.6 PA66+PA6I/6T GF30
AKROLOY® PA GF 30 natural (6412)
AKROLOY® PA GF 30 natur (6412) is a 30% glass fibre reinforced, semi-aromatic polyamide blend with high stiffness and strength, even in conditioned state.
Components with high dimensional stability, independent from moisture content. AKROLOY® PA GF 30 is an alternative for aluminium- and zinc diecast alloys.
The listed values are recommendations. Higher values should be used for higher glass loadings. We recommend only de-humidifying or vacuum dryers. Extensive drying can cause filling problems and surface defects.
|Drying time||0 - 4 h|
|Drying temperature (τ ≤ -30°C)||80°C|
|Processing moisture||0,02 - 0,1%|
|Feed section||60 - 80°C|
|Temperature zone 1 - Zone 4||260 - 300°C|
|Nozzle temperature||270 - 300°C|
|Melting temperature||280 - 300°C|
|Mold temperature||90 - 130°C|
|Holding pressure, spec.||300 - 800 bar|
|Back pressure, spec.||50 - 150 bar|
|Injection speed||medium to high|
|Screw speed||8 - 15 m/min|
- Mechanical Properties
Tensile modulus (1 mm/min | ISO 527-2) d.a.m. 10200 MPa Stress at break (5 mm/min | ISO 527-2) d.a.m. 200 MPa Strain at break (5 mm/min | ISO 527-2) d.a.m. 2,9 % Flexural modulus (2 mm/min | ISO 178) d.a.m. 9500 MPa Flexural strength (2 mm/min | ISO 178) d.a.m. 280 MPa Flexural strain at break (2 mm/min | ISO 178) d.a.m. 3,4 % Charpy impact strength (23°C | ISO 179-1/1eU) d.a.m. 70 kJ/m² Charpy notched impact strength (23°C | ISO 179-1/1eA) d.a.m. 11 kJ/m²
- Thermal Properties
Temperature of deflection under load HDT/A (1,8 MPa | ISO 75) 235 °C Temperature of deflection under load HDT/C (8 MPa | ISO 75) 120 °C Melting temperature (DSC, 10K/min | DIN EN 11357-1) 255 °C
- General properties
Density (23°C | ISO 1183) 1,36 g/cm³
- Rheological Properties
Flowability (1mm Thickness | AKRO) 160 mm Flowability (2mm Thickness | AKRO) 500 mm
All specifications and information given on this website are based on our current knowledge and experience. A legally binding promise of certain characteristics or suitability for a concrete individual case cannot be derived from this information. The information supplied here is not intended to release processors and users from the responsibility of carrying out their own tests and inspections in each concrete individual case. AKRO®, AKROMID®, AKROLEN®, AKROLOY®, AKROTEK®, ICX® and PRECITE® are registered trademarks of the Feddersen Group.
You have questions about our products?
With a worldwide network of plastics distribution experts, we can provide you with support anywhere in the world. Talk to one of our specialists to find out more.CONTACT US NOW