PA6 GF 25 FR (40)
AKROMID® B3 K1 FR natural (8045)AKROMID® B3 K1 FR natural (8045) is a 25 % glass fibre reinforced and flame retardant PA 6. The flame retardant system is free of halogens and red phosphorus. Due to its high stiffness and strength, the material is suitable for panels, arm rests, protective caps and other small parts. It meets the requirements of EN 45545-2 R21 HL3, R22/23/24 HL2 for public transportaition. The very good flowability achieved an improved surface quality and it is optimized for self coloration.
Properties
Tensile Modulus Tensile Strength Impact StrengthFeatures
-
Mechanical Properties
Tensile modulus (1 mm/min | ISO 527-2) d.a.m. 9500 MPa conditioned 5900 MPa
Stress at break (5 mm/min | ISO 527-2) d.a.m. 139 MPa conditioned 95 MPa
Strain at break (5 mm/min | ISO 527-2) d.a.m. 3,2 % conditioned 6,5 %
Charpy impact strength (23°C | ISO 179-1/1eU) d.a.m. 66 kJ/m²
-
Thermal Properties
Melting temperature (DSC, 10K/min | DIN EN ISO 11357-3) 220 °C
-
Flammability
Burning rate (UL 94) 0,8mm Wall thickness V-1 Class 1,6mm Wall thickness V-0 Class 3,2mm Wall thickness V-0 Class
Oxygen index (ISO 4589-2) >28 %
Burning rate (<100 mm/min) (> 1 mm Thickness | FMVSS 302) +
Protection Train (EN 45545-2) R21 HL3, R22/23/24 HL2
-
General properties
Density (23°C | ISO 1183) 1,39 g/cm³
Molding shrinkage (flow | ISO 294-4) 0,2-0,4 %
Molding shrinkage (transverse | ISO 294-4) 0,6-0,8 %
Processing information
The listed values are recommendations. Higher values should be used for higher glass loadings. We recommend only de-humidifying or vacuum dryers. Extensive drying can cause filling problems and surface defects.
Drying time | 2 - 4 h | |
Drying temperature (τ ≤ -30°C) | 80°C | |
Processing moisture | 0,02 - 0,08% | |
Feed section | 60 - 80°C | |
Temperature zone 1 - Zone 4 | 220 - 280°C | |
Nozzle temperature | 240 - 280°C | |
Melt temperature | 240 - 280°C | |
Mold temperature | 60 - 100°C | |
Holding pressure, spec. | 300 - 800 bar | |
Back pressure, spec. | 30 - 100 bar | |
Injection speed | medium | |
Screw speed | 5 - 10 m/min | |
Disclaimer
All specifications and information given on this website are based on our current knowledge and experience. A legally binding promise of certain characteristics or suitability for a concrete individual case cannot be derived from this information. The information supplied here is not intended to release processors and users from the responsibility of carrying out their own tests and inspections in each concrete individual case. AKRO®, AKROMID®, AKROLEN®, AKROLOY®, AKROTEK®, ICX® and PRECITE® are registered trademarks of the Feddersen Group.