PPA – Polyphthalamide PPA GF35
AKROMID® T5 GF 35 6 natural (8005)
AKROMID® T5 GF 35 6 natural (8005) is a 35% glass fibre reinforced, inorganic high temperature stabilised polyphthalamide with high rigidity and strength, as well as high temperature and chemical resistance
Typical applications
Applications are parts with tight dimensional tolerances even under high mechanical load.
Processing information
The listed values are recommendations. Higher values should be used for higher glass loadings. We recommend only de-humidifying or vacuum dryers. Extensive drying can cause filling problems and surface defects.
Drying time | 0 - 4 h | |
Drying temperature (τ ≤ -30°C) | 120°C | |
Processing moisture | 0,02 - 0,1% | |
Feed section | 60 - 90°C | |
Temperature zone 1 - Zone 4 | 320 - 350°C | |
Nozzle temperature | 330 - 350°C | |
Melt temperature | 330 - 350°C | |
Mold temperature | 120 - 160°C | |
Holding pressure, spec. | 300 - 800 bar | |
Back pressure, spec. | 50 - 150 bar | |
Injection speed | medium to high | |
Screw speed | 8 - 15 m/min | |
-
Mechanical Properties
Tensile modulus (1 mm/min | ISO 527-2) d.a.m. 12500 MPa
Stress at break (5 mm/min | ISO 527-2) d.a.m. 230 MPa
Strain at break (5 mm/min | ISO 527-2) d.a.m. 2,3 %
Charpy impact strength (23°C | ISO 179-1/1eU) d.a.m. 70 kJ/m²
-
Thermal Properties
Melting temperature (DSC, 10K/min | DIN EN 11357-1) 325 °C
-
Flammability
Burning rate (UL 94) 0,8mm Wall thickness HB Class
Burning rate (<100 mm/min) (> 1 mm Thickness | FMVSS 302) +
-
General properties
Density (23°C | ISO 1183) 1,45 g/cm³
Molding shrinkage (flow | ISO 294-4) 0,2-0,4 %
Molding shrinkage (transverse | ISO 294-4) 0,6-0,8 %
Disclaimer
All specifications and information given on this website are based on our current knowledge and experience. A legally binding promise of certain characteristics or suitability for a concrete individual case cannot be derived from this information. The information supplied here is not intended to release processors and users from the responsibility of carrying out their own tests and inspections in each concrete individual case. AKRO®, AKROMID®, AKROLEN®, AKROLOY®, AKROTEK®, ICX® and PRECITE® are registered trademarks of the Feddersen Group.
You have questions about our products?
With a worldwide network of plastics distribution experts, we can provide you with support anywhere in the world. Talk to one of our specialists to find out more.
CONTACT US NOW