PA6.10 – Polyamide 6.10 PA610 + PP
AKROMID® S4 4 L black (7668)
AKROMID® S4 4 L black (7668) is a unreinforced, hydrolysis stabilised, higher viscous polyamide-blend with a reduced density compared to standard PA610
Technical components of cooling water cycles in the automotive industry.
The listed values are recommendations. Higher values should be used for higher glass loadings. We recommend only de-humidifying or vacuum dryers. Extensive drying can cause filling problems and surface defects.
|Drying time||0 - 4 h|
|Drying temperature (τ ≤ -30°C)||80°C|
|Processing moisture||0,02 - 0,1%|
|Feed section||60 - 80°C|
|Temperature zone 1 - Zone 4||230 - 270°C|
|Nozzle temperature||230 - 280°C|
|Melt temperature||250 - 270°C|
|Mold temperature||40 - 80°C|
|Holding pressure, spec.||300 - 800 bar|
|Back pressure, spec.||50 - 150 bar|
|Injection speed||medium to high|
|Screw speed||8 - 15 m/min|
Tensile modulus (1 mm/min | ISO 527-2) d.a.m. 1100 MPa
Stress at yield (50 mm/min | ISO 527-2) d.a.m. 30 MPa
Strain at break (50 mm/min | ISO 527-2) d.a.m. 50 %
Charpy impact strength (23°C | ISO 179-1/1eU) d.a.m. n.b.
Charpy notched impact strength (23°C | ISO 179-1/1eA) d.a.m. 80 kJ/m²
Melting temperature (DSC, 10K/min | DIN EN 11357-1) 220 °C
Density (23°C | ISO 1183) 0,99 g/cm³
Molding shrinkage (flow | ISO 294-4) 1,3-1,5 %
Molding shrinkage (transverse | ISO 294-4) 1,5-1,7 %
All specifications and information given on this website are based on our current knowledge and experience. A legally binding promise of certain characteristics or suitability for a concrete individual case cannot be derived from this information. The information supplied here is not intended to release processors and users from the responsibility of carrying out their own tests and inspections in each concrete individual case. AKRO®, AKROMID®, AKROLEN®, AKROLOY®, AKROTEK®, ICX® and PRECITE® are registered trademarks of the Feddersen Group.
“conditioned” test values = conditioned, measured on test specimens stored according to DIN EN ISO 1110
“d.a.m.” = dry as moulded test values = residual moisture content <0.1%
You have questions about our products?
With a worldwide network of plastics distribution experts, we can provide you with support anywhere in the world. Talk to one of our specialists to find out more.CONTACT US NOW